J
*
Light Switches
m
When
the switch is turned to this
position,
headlight,
rear light, instrument
panel
light, and
position
light will
go
on.
W
When the switch is turned to this
position,
rear light, instrument
panel
light,
and
position light
willgo
on.
When the switch is turned to this
position,
all
lights
will
go
off.
(Depending
on
Models)
o
Electrical
starter
Button
This is the electrical starter button.
lt is
used
for
startinc the enaine.
When the ignition switch key turns to
"ON"
and brake
lever hold,
and
then
press
this
button down to start engine.
This mechanism is
designed
for safety, Thus, the
front or
rear
brake
lever must be hold before usinq this button so that enqine can be started.
CAUTION:
a
Release this button immediately after engine
has
been started.
Never
press
the button again
during the engine is running.
This
could
lead to
seriously defects
on the engine.
a
Do not use light system during starting the engine.
Turn
headlight and turn
signal lights to the
"OFF"
position
when
the
engine is being started,
o
High/Low Beam Switch
This is the
high
and low beam of
headlight switching
switch,
Press this switch to switch
between
hioh and
low
beams.
l!Dlrnis
is for hich beam.
@]rhi=
is for loir
beam.
(Please
turn to
low
beam when riding in city)
o
Turn
Signal
Switch
Turn signal lights are used when turning
left/right
or changing
lane.
Turn ignition switch to
"ON",
and slide the turn signal switch to
left
or
right. Then, the turn signal
lights
willflash. lf
you
press
the middle of the
switch the
indicator
willturn off.
1*]Right-side
turn signal
light flashing means
you
intend to make a right turn.
l{?lleft-siOe
turn signal
light flashing means
you
intend
to
make
a
left turn,
o
Horn Switch
lffilPress
this button
down
when ignition switch is
in
the
"ON"
position,
the
horn willsound.
o
CAUTION;
Do not
press
this button
when you
are
in
the
no horn
area.
m
t*--
To Next Page
Loading...
Need help?
General
