10
1010
10
absolute fidelity
the black alligator clip at the XLR end of the interconnect to the
chassis of the servo-bass amplifier. A convenient attachment point
is the bright locking tab on the XLR at the amplifier end.
If this does not work, take disconnect the clip, and then try
connecting the black alligator clip at the other end to the chassis of
your power amplifier.
Do NOT attach the ground tab to the negative loudspeaker terminal
if you are not sure if you have a fully balanced floating output on
your power amplifier. You could destroy your power amplifier, or
your woofer tower if you do.
If you are using the preamplifier to drive the servo-bass amplifier,
you may have a ground loop. In this case, if your hifi system is
grounded at the preamplifier, you may have to lift the ground on the
servo-bass amplifier.
To Next Page
Loading...
