14
Patented seat post with one-screw attachment
* see page 34
Attachment with seat clamps
Suspension seat posts:
Integrated Seatpost
If your bicycle is equipped with a so-called in-
tegrated xture: or operation and adjustment
please read the enclosed instructions from the
respective manufacturer.
Before you start riding, please test to
see if your seat post and seat are se-
cure. To do this, grab the seat at the
front and back and attempt to turn it. It should
not move.
/
If your mountain bike is
equipped with a telescopic
seat post, please ensure
you read the instructions
provided by the manufac-
turer before use.
When adjusting the height of the
seat, never pull the seat post further
out than the maximum extension
length marked! If your tube does not have a
maximum marking, then you must leave a
minimum insertion length of 7.5 cm.
Please ensure that you read the part
manufacturer‘s operating manual
when setting up and operating sus-
pension seat posts telescopic seat posts.
Height adjustment is possible
Setting up the position of the handlebars/
stem
Various types of stem are used on bicycles:
Threadless stem
7,5 cm
For bikes with rear suspension, the seat post
should never come in contact with any part of the
rear suspension.
To Next Page
Loading...
