5-71
0055
• Setting Warning Volume
The diver can select the warning
volume from the Settings menu in
the AVN system screen. Select:
- Setup → Vehicle Settings →
Driver Assistance → Warning
Volume → High/Medium/Low/Off
For detailed information, scan
the QR code in a separately sup-
plied simple manual.
Information
If you change the warning volume, the
warning volume of other systems may
change.
Operating conditions
The system enters the ready status,
when 'Active Assist' or 'Warning
Only' is selected in the AVN system
screen and the following conditions
are satisfied:
• Active Assist
1) The Blind-Spot Collision-Avoidance
Assist system will operate when:
- Vehicle speed is above 40 mph
(60 km/h)
- The system detects both of the
lane lines.
- An approaching vehicle is detect-
ed next to or behind your vehicle.
2) The Blind-Spot Collision Warning
system will operate when:
The vehicle speed is above
approximately 20 mph (30 km/h).
• Warning Only
1) The Blind-Spot Collision Warning
system will operate when:
- The vehicle speed is approxi-
mately 20 mph (30 km/h).
- The Blind-Spot Collision-
Avoidance Assist system is not
activated when "Warning Only" is
selected for the system setting.
i
To Next Page
Loading...
