Genesis GHD1275 - Page 9

9
English
LOCK-ON BUTTON


To Lock the Trigger “ON”

To Unlock the Trigger,

FORWARD/REVERSE SELECTOR




For Forward Rotation
For Reverse Rotation,
WARNING: Do not change the direction of rotation until the tool comes to a
complete stop. Moving the “forward/reverse” lever while the drill chuck is rotating can
cause damage to the tool.
WARNING: Always check the direction of rotation before tool operation.
WARNING: This drill is not designed for hammering in the reverse or counter-
clockwise direction. Failure to comply with this caution may cause property damage.
MODE SELECTOR





To Select the Drill Only Mode

To Select Hammering Action or Hammer Drill Mode


NOTE: 

NOTE: 

WARNING: Do not change the operating mode until the tool has come to
a complete stop. Moving the mode selector while the drill is operating can cause
damage to the tool.
INSTALLING BITS



WARNING:Always be sure that the tool is switched off and unplugged before
adjusting, adding accessories, or checking a function on the tool. Failure to unplug the
tool could result in accidental starting causing possible serious injury.
To Install a Drill Bit:
 
 
 

