INFOTAINMENT
Quick Reference Guide I 34
33 I Quick Reference Guide
GENESIS GV70
Rolling Code Programming
•You may need a ladder to access your garage door opener.
•You may need help from a second person.
•Be prepared some of the steps are time sensitive.
1. Firmly press and release the “Learn”, Smart”, or “ Program” button
of garage door opener on the ceiling while the indicator
7
flashes
in Green. Once the button is pressed, you have approximately 30
seconds to initiate the next step.
2. Return to the vehicle and firmly press the HomeLink button, hold for
two seconds and release the button up to three times. Do not press
the HomeLink button rapidly. At this point programming is complete
and your device should operate.
For more detailed information, please refer to your Owner’s manual or
visit www.homelink.com or call (800) 355-3515
Indicator
4
&
6
:
Flashes in orange → “Closing” & “Opening”
Solid Green → “Closed” & “Opened”
4
6
NOTE:
If your garage door opener has Two-Way Communication
functionality, it is possible for HomeLink to stop functioning the garage
door shortly after initial programming, if the Two-Way Communication
Programming wasn’t properly completed. If you experience this,
completing the “Programming a New HomeLink Button” and “Two-
Way Communication Programming” will restore door operation.
SHIFT BY WIRE (Electronic type shifter)
To shift the gear to P (Park), press
the P button while depressing the
brake pedal.
To shift the gear to N (Neutral), rotate
the shift dial clockwise from R
(Reverse) or counterclockwise from
D (Drive) while depressing the brake
pedal.
To shift the gear to R (Rear), rotate
the shift dial counterclockwise while
depressing the brake pedal.
A
B
C
A
Rotary shifter (Rotary gear
shift dial),
B
Park button,
C
P
Release Cap
Paddle Shifter (Manual Shift Mode)
Press (-) to
downshift
Press (+) to
upshift
The Paddle shifter is available
when the shift lever is in the D
position.
Press the [+] or [-] paddle shifter
once to shift up or down one gear.
NOTE:
To exit manual shift mode, pull and hold (+) paddle shifter for more
than 3sec.
DRIVING
To Next Page
Loading...
