Genesis GV70 - Driving: Parking Brake, Auto Hold, and Fingerprint; Parking Brake, Auto Hold, and Fingerprint System

DRIVING
Quick Reference Guide I 44
43 I Quick Reference Guide
GENESIS GV70
AUTO HOLD
To cancel the AUTO HOLD operation, press the AUTO HOLD
switch again.
The Auto Hold feature assists in
steep hill areas. It holds the brake
until the accelerator pedal is
pressed.
1. Press the AUTO
HOLD switch.
2. Stop the vehicle by
pressing the brake
pedal. The brakes will
remain engaged even
if the brake pedal is
released.
3. The brakes will release
when the accelerator
pedal is pressed with
transmission in D, R or
manual mode.
R
AUTO
HOLD
N
D
P
R
AUTO
HOLD
N
D
P
WHITE
GREEN
WHITE
R
AUTO
HOLD
N
D
P
R
AUTO
HOLD
N
D
P
ELECTRIC PARKING BRAKE (EPB)
Applying
Releasing
NOTE: If necessary,
emergency braking
is possible by pulling
and holding the EPB
switch.
MAP
NAV
MAP
NAV
MAP
NAV
MAP
NAV
To apply EPB
(Electronic Parking Brake)
1. Depress and hold the brake pedal.
2. Pull up the EPB switch. Make sure
the Parking Brake warning light
comes on.
To release EPB
(Electronic Parking Brake)
1. Press the Engine Start/Stop button
to the ON or START position.
2. Press the EPB switch while
depressing the brake pedal. Make
sure the Parking Brake warning light
goes off.
FINGERPRINT AUTHENTICATION SYSTEM (if equipped)
1. Turn on the vehicle with a smart key.
2. Select ‘Setup > User Profile Settings > Driver 1 > Fingerprint
identification > Set/Delete Fingerprint > Set’ in the infotainment
system screen.
3. Place your finger that you wish to enroll on the fingerprint sensor.
4. Following the instructions, place several parts of your fingerprint
until the scanning process is complete.
5. Once the scanning process is completed, the message ‘Saving
fingerprint….’ appears and the fingerprint enrollment process is
proceeded.
6. When the fingerprint enrollment process is completed in the
vehicle, the status is displayed on the infotainment system.
Fingerprint authentication system allows the driver to start the
engine, have access to personal information, unlock profile and exit
valet mode with a enrolled fingerprint.
Fingerprint Authentication
System Settings
To use the system, the driver’s
fingerprint should be enrolled in the
driver’s profile. The drivers can set
or delete their fingerprint through
the infotainment system. Follow
the following procedure.