Installation
Cabinet
Twin Tank
• Place the softener as close as possible to the pressure tank (well
system) or water meter (city water) and a floor drain or other
acceptable drain point (laundry tub, sump, standpipe, etc.).
• Connect the softener to the main water supply pipe BEFORE the
water heater. DO NOT RUN HOT WATER THROUGH THE
SOFTENER. Temperature of water passing through the softener
must be less than 100 deg. F.
• Keep outside faucets on hard water to save soft water and salt.
• Do not install the softener in a place where it could freeze.
Damage caused by freezing is not covered by the warranty.
• Put the softener in a place water damage is least likely to occur
if a leak develops. The manufacturer will not repair or pay for
water damage.
• A 120 volt electric outlet, to plug the included transformer into, is
needed within 6 feet of the softener. Be sure the electric outlet and
transformer are in an inside location, to protect from wet weather.
• If installing in an outside location, you must take the steps
necessary to assure the softener, installation plumbing, wiring, etc.,
are as well protected from the elements, contamination, vandalism,
etc., as when installed indoors.
• Keep the softener out of direct sunlight. The sun’s heat may soften
and distort plastic parts.
To Previous Page
Loading...