1 2 3
4 5 6
7 8 9
* 0 #
1
2
3
4
5
6
7
8
9
*
0
#
1
2
3
4
5
6
7
8
9
*
0
#
1 2 3
4 5 6
7 8 9
* 0 #
1 2 3
4 5 6
7 8 9
* 0 #
UNIVERSAL GARAGE DOOR
KEYLESS ENTRY SYSTEM
2242923617
MODELS KEP-1 AND KEP-1A
INSTALLATION AND
OPERATING INSTRUCTIONS
SAFETY CAUTION
The Genie® Keyless Entry System includes everything required for most
residential garage installations. The contents include the code pad with
signal tail, control box, wall transformer, two (2) 25' rolls of wire and a
parts bag containing insulated staples and fasteners.
1. Select a convenient location for the code pad on the outside door jamb or
wall. BE CERTAIN THE LOCATION IS OUT OF THE AREA OR PATH OF THE
MOVING GARAGE DOOR AND SUPPORTING HARDWARE.
Figure 1 illustrates the code pad installed on the door jam. A wall installation is
illustrated in Figure 2. IMPORTANT: Do not allow children to play games with
the door.
2. For door jam mounting, momentarily pry the door stop away from the jam and
slide the signal tail between and into the garage, Figure 3. Secure the code pad
to the jam with the four brass screws supplied. CAUTION: JAM MOUNTING
SHOULD NOT BE USED FOR ONE-PIECE GARAGE DOORS. For wall mounting,
drill a 1/2" hole through the garage wall at the selected location. Carefully
insert the signal tail through the hole and into the garage., Figure 4. Be sure you
route all connecting wire away from the garage door to ensure it cannot be
snagged by the door or door hardware. Secure the code pad to the wall with
the four brass screws supplied.
3. Remove the cover of the control box by pressing inward on the sides and
pulling up. The signal tail plugs into the control box, therefor, position the box
on the interior wall of the garage within reach of the signal tail. Proper
positioning is illustrated in Figure 5. Secure the control box with the two
1" screws supplied.
Prior to installing the Keyless Entry System, be certain to disconnect
the electrical power to the garage door opener. Most garage door
openers feature a manual release device. Since automatic operation
of the door will not be possible after power is disconnected, we
suggest you disengage the opener per the manufacturer's
instructions. This will allow manual operation of the garage door
during installation of the Keyless Entry System.
Code Pad
Transformer
2-Conductor Wire (2)
Control Box
Parts Bag
The Genie® Company
1 Door Drive
Mt. Hope, OH 44660
For help call 1-800-654-3643
INSTALLATION
Door
Jam
Door Jam
Code
Pad
Outside
Garage
Wall
Code
Pad
Door
Stop
Door
Door
Figure 1 Figure 2
Figure 3 Figure 4
Door
Stop
Outside
Garage
Wall
Garage
Door
Signal
Tail
Signal
Tail
1/2" hole
Garage
Interior
To Next Page
Need help?
General