IMPORTANT: For ID#4 Chamberlain®/LiftMaster®/Craftsman® Yellow Learn Button - move
immediately to instructions on pg 6. For all other ID#s, proceed. For a brief explanation on
Marantec® openers, see pg 7.
1. On universal remote, press and hold down button #1
2. While still holding down button #1, press button #2 on universal remote four times
3. Release both buttons - WHITE LED flashes slowly.
4. Place the existing, operational remote and universal remote within 4” of each other
5. Hold down the operational button from the original remote. Do not release until the
new universal remote blinks change from slow WHITE blinks to rapid BLUE blinks. You
will have 20 seconds to complete.
TIP: If the universal remote does not recognize the transmission, try different distances between 0”-4”
away from the side of the universal remote closest to button numbers 1 and 3.
6. Once the universal remote BLUE LED is blinking rapidly, press the button of choice on
the universal
remote ONE TIME. The BLUE LED turns solid and goes out.
7. On opener, press LEARN/PROGRAM button for 2-3 seconds and then release.
8. Press and release button you just programmed once every 2 seconds until the garage
door opener
operates.
9. Test the button - programming is complete.
TIP: Allow the LED light on the universal transmitter to stop flashing before your next button press.
To Next Page
Loading...
