4
Before tting the handle, remove the protective cover from the screw-x element on the side of the pan.
During tting, take special care to see that the screw screws in easily. If this is not the case, then the
screw is sitting at an angle to the thread. Screw out the screw and re-enter making sure the screw is
aligned with the thread. Never use force. Screws entered with force can lead to damage to the internal
thread and the handle can never be xed in position again.
Do not use a pan with a loose handle – certain danger of injury!
Caution!
Assembly
Before you can use your Cerat Fusion pan for the rst time you have to x the handle to the pan (Ø 20 cm)
and the knob onto the glass lid. The handles are numbered to match the pans. Before you x them, please
ensure that you have selected the right handle. The knobs also have screws with matching lengths, which have
to be used just for that particular lid. Unless you use the correct screws, you will not be able to x the knobs
and handles.
Pan Handle Spring ring Screw
Ceramic pan (20 cm) Not removable, Number 20 1 x 1 x 18 mm
List of materials for xing the handles on the ceramic pan (Ø 20 cm)
Fixing the handle
Spring ring
Follow the instructions below:
To Next Page
Loading...
Need help?
General
