1. Install the blade insert on the pin in the mixing bowl.
2. Place the prepared food in the mixing bowl.
3. Install the motor unit on the mixing bowl.Connect the pin
on the underside of the motor unit to the blade insert.
Beware of the notches on the edges of the motor unit.
4. If the motor unit is installed correctly, the indicator
light ashes blue repeatedly.
5. Press and hold the start button. The blade rotates if the
start button is pressed and automatically stops after 30
seconds. The device only functions if it is assembled
correctly.
6. To stop the device, release the start button. Repeat the
process until you have the desired consistency.
7. Wait until the blade has come to a complete stop. Then
remove the motor unit.
8. Remove the blade carefully .
9. Empty the mixing bowl.
6. Cleaning and care
Do not use any sharp or abrasive cleaning agents or cleaning pads. The blades are sharp
- risk of injury! Do not touch the blades with your ngers. Always hold the blade insert
by the plastic section.
NOTE: Before processing, cut food into smaller pieces, remove stones and seeds and peel if
necessary.
For safety reasons, do not use the device while it is connected to a power supply. Do not
process hot food! The contents must not be warmer than 50°C otherwise there is a risk of re.
Do not overll the device . Fill to a maximum of 2/3.
The device is not designed for continuous operation. Use for max. 30-second intervals .
A cooling phase is required after 2 minutes.
CAUTION!
14
Instruction Manual
GB
To Next Page
Loading...
