Need help?Do you have a question about the Genius SW-2.1 300 and is the answer not in the manual?
General| Type | 2.1 |
|---|---|
| Signal-to-Noise Ratio | 70dB |
| Controls | Volume, Bass |
| Frequency Response | 100 Hz - 20 kHz |
| Input | 3.5mm stereo |
| Input Impedance | 10k ohm |
| Power Supply | AC 220V~50Hz |
Steps to connect the speakers to the host speaker, AC outlet, and audio source.
Turn system on/off and control volume level with the Volume button.
Controls the speaker's bass level using the Bass button.
Avoid connecting power until all connections are made; unplug when not in use; protect from liquids.
To Next Page
