To Next PageTo Next Page
Need help?Do you have a question about the Genz Benz El Diablo 100 and is the answer not in the manual?
Describes the unbalanced, high impedance 1/4" input for instrument connection.
Sets gain level for the warm channel, works with gain control. Leave out for footswitch.
Adjusts gain for the warm channel from clean to vintage sustain.
Controls overall preamp volume for the warm channel.
Three pre-selected EQ circuits for articulate, full-range tone shaping.
Adjusts signal send level to the onboard reverb for the warm channel.
Switch and indicator lights to select between warm or hot channels. Leave out for footswitch.
Sets gain structure for the hot channel. Leave out for footswitch.
Changes hot channel character between dynamic and compressed.
Provides gain settings from clean to fully overdriven high gain.
Preamp volume control for the hot channel.
Adds a tone stack within the preamp for midrange or modern character.
Three EQ circuits for articulate, full-range tone shaping.
Adjusts return signal level from the onboard reverb.
Boosts upper mid frequencies for enhanced pick attack and bite.
Provides a variable amount of attack boost.
Adjusts the return level of the onboard reverb.
Controls the final output stage and master volume.
Removes high voltage from output tubes for protection during warm-up.
Turns on the AC power to the amplifier.
Chart for choosing correct fusing for international voltage.
Changes the AC power voltage for amp operation (115V/230V).
Connects detachable power cord and houses the mains power fuse.
6-pin DIN connector for the 5-button footswitch.
Jack for a single-button footswitch to control reverb.
Post-master section loop for external effects or connecting to other amps.
Serial effects loop for the hot channel.
Serial effects loop for the warm channel.
1/4" jack providing frequency-compensated unbalanced line level output.
XLR jack providing frequency-compensated balanced line or mic level output.
Sets nominal output level for unbalanced and XLR outputs (0dBv/-30dBv).
Lifts pin 1 on XLR balanced output to break ground loops.
Parallel jacks for connecting guitar cabinets.
Selects output transformer impedance tap for the chosen cabinet load.
Chart to determine correct impedance for guitar cabinets.
Reduces output power from 100W to 50W by disconnecting power tubes.
Sets the correct bias for the power tubes used (EL34/6L6).
Explains the requirements for biasing tube amplifiers.
General
