EasyManua.ls Logo

GENZE E101 - Assembly and Adjustment; How to Adjust Gears

GENZE E101
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rear Derailleur
Push the shifting lever
Pull the
shifting lever
Low speed riding
High speed riding
Adjusting gearsRear derailleur
18 / 19
If your GenZe e-Bike is not shifting correctly you should
contact your local GenZe service or dealer. However, minor
adjustments can be made following these simple instructions:
Shift to the smallest sprocket; gear 7.
Check for excessive slack in the exposed derailleur cable.
Inspect the shifter cable for improper tension or kinks.
If when selecting the next higher gear the derailleur does not
engage the higher gear, turn the black barrel adjuster (See
figure A) on the derailleur counter-clockwise one or two turns
until the shift is completed. Continue to make small adjust
ments until the derailleur engages the next higher
gear smoothly.
If the black barrel adjuster cannot be turned any further
there is excessive slack in the cable tension, the cable needs
to be reset (See figure B)
If when selecting the next lower gear the derailleur does not
engage the lower gear, turn the rearmost adjuster on the
derailleur clockwise one or two turns and attempt the shift
again. Continue to make small adjustments until the derailleur
engages the next lower gear smoothly.
If excessive drivetrain noise is heard from the derailleur, with
the e-bike on its center stand and after shifting to the highest
(7th) gear, begin turning the pedal crank moderately while
adjusting the screw adjuster on the derailleur marked “H” in
small increments in either direction until the noise is eliminat
ed. Now shift to the lowest (1st) gear and complete the same
task as before, this time with the screw adjuster on the
derailleur marked “L”.
If any drivetrain problems still exist, consult your local retailer
or a GenZe technical service center by calling
1-855-GO-GENZE.
5. Assembly and Adjustment
1. Mounting Bolt
2. Cable and Housing
3. B-Tension Adjuster
4. Barrel Adjuster
5. Cable Bolt
6. Limiter Screws (L&H)
7. Upper Pulley
8. Cage
9. Lower Pulley
1
2
3
4
5
6
7
8
9
How to Adjust Gears

Related product manuals