Comfort Controls
and
Audio
Systems
Pushbuttons:
The six pushbuttons let you
return to your favorite stations. To set
the
pushbuttons for up to
18
stations
(6
AM,
6
FM1
and
6
FM2), jus#:
1.
Tune
in
the station.
2.
Press and hold one
of
the pushbuttons
for more than two seconds. The sound
will go away for a second and will
return when the station is stored.
Repeat these steps for each pushbutton.
Preset Scan:
Press the “PRESET SCAN’
button
to
hear each of your preset stations
for a few seconds. When you want to stop
at a Chosen statioq, press “PRESET
SCAN” again.
Setting the Tone
Treble:
Turn the “TREB” knob to the
right to hear more treble.
Bass:
Turn the“BASS” control behind
the “TREB” knpb to the right to hear
more bass.
Treble and bass cannot be adjusted
manually when “TONE SELECT” is on.
Loud:
To
increase the bass tone at low
volumes, press the
“LOUD”
button.
Tone Select:
Press
“TONE
SELECT”
to
choose preset treble and bass equalization
settings designed for “ROCK,”
“NEWS,”
”POP,”
“JAZZ’ and “CLASSICAL.”
“ROCK” will appear when you first press
“TONE SELECT.” Each time you press
it, another setting will appear on the
display. Press
it
after “CLASSICAL” and
tone control will be back to the treble and
bass knobs.
Adjusting the Speakers
Fade:
Turn
the
“FADE’ knob to move the
sound between the front and rear
speakers.
Balance:
Turn the
“BAL”
control behind
the “FADE” knob to move the sound
between the
right
and left speakers.
Recall
Press “RCL” to see the station being
played for a moment. Or, press it if you
want to see the time when the ignition is
off.
To
Play a Cassette Tape
Your tape player is built
to
work best with
tapes that are
30
to
45
minutes long on
each side. Tapes longer than that are
so
thin they may not work well in this player.
The longer side with the tape visible
should face to the right.
If
you hear
nothing or hear just a garbled sound, it
may not be in squarely. Press
“MA”
to
remove the tape and start over.
Once the tape is playing, use the knobs
for volume, fade and balance, just as you
do
for radio. The lighted arrows show
which side of the tape is playing.
Metal Tapes:
Your
bias is set
automatically. When a metal or chrome
tape
is
inserted,
“MTL”
will appear on the
display.
Fast Forward:
Press “FF” to advance
rapidly to another part of the tape. Press
“FF,”
“RCL/PROG’ or
“HA”
to return to
playing speed.
Rewind:
Press “REV to reverse the tape
rapidly. Press
“RW,”
“RCL/PROG” or
“.A”
to return to playing speed.
Next Selection:
Press
“NEXT”
to go
forward to the beginning of the next
selection. Press
“NEXT”
again or press
“RCLPROG’ or
‘,.A’’
to cancel this
function.
For “NEXT” to work properly, your tape
must have
at
least three or four seconds of
silence between each selection.
...
90
To Next Page
Loading...
