Previous Selection:
Press “PREV”
to
go
back
to
the beginning of the last selection.
Press “PREV” again or press
“RCL/PROG” or
“HA’,
to
cancel this
function.
Program:
Press “RCL/PROG”
to
switch
from one side of the tape
to
the other.
Your cassette tape player can play
continuously because the player has
an
auto-reverse feature.
Noise Reduction:
Press
00
@to
remove
noise from Dolby@
B
NR-encoded tapes.
Dolby@
B
Noise Reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
“Dolby@” and the
00
@symbol are
trademarks of Dol by Laboratories
Licensing Corporation.
Eject:
Press
“HA’,
to
remove the tape
and
switch
to radio.
Radio Monitor:
Press the “RADIO
MNTR” button to hear the radio when
you are fast forwarding or reversing
a
cassette tape. You can use the “TUNE,“
“SEEK”
and “PRESET-SCAN?’ buttons
while
in
the radio monitor mode.
rheft Deterrent Feature
The theft deterrent feature for the AM/FM
;tereo
with
cassette tape player can be
lsed or ignored. If ignored, the system
Aays normally.
If
it
is used, your system
won‘t be usable
if
it’s ever stolen.
Setting Your Security Code
The instructions below tell you how
to
mter a security code into the system.
If
qour vehicle loses battery power for
any
-eason, you must enter the security code
lgain before
the
system will
turn
on.
1.
Write down any four-digit number and
keep
it
in
a safe place.
2.
Turn on the ignition switch
to
the
“ACC” or “ON” position.
3.
Turn the audio system off.
4.
Press the
“1”
and
“4”
buttons together.
Hold them down
until
“-
-
-
-”
shows
on the display.
You are now ready
to
enter your security
code. Don’t wait more than 15 seconds
between steps.
5.
Press
“4
SEEK
b’’
and/or
“+
TUNE
,’’
and
“0000”
will appear
on the display.
first digit of your code appears.
Release the button.
6.
Press “SEEK+” and hold
it
until
the
7.
Press
“SEEK
F”
and hold
it
until
the
second digit of your code appears.
Release the button.
8.
Press “TUNE
+”
and hold
it
until
the
third digit
of
your code appears.
Release the button.
9.
Press “TUNE
F”
and hold it
until
the
fourth digit of your code appears.
Release the button.
10.
Press
“AM-FM”
after you have
checked that the code you entered is
the one you wrote down. “rEP” will
appear
in
the display, which means
you need
to
repeat steps 5 through
9.
will
now show
“SEC.”
11.
Press “AM-FM” again and the displaJ
91
...
To Next Page
Loading...
