GEONAUTE SCALE 300 - User Manual

Questions and Answers

S
Sierra ParksJul 31, 2025
What to do if GEONAUTE SCALE 300 show abnormal measuring results?
- F
  fsmithJul 31, 2025
  If your GEONAUTE Scales are showing results that are too high, too low, or vary significantly between measurements, consider the following: * Ensure you are standing barefoot and still on the platform. * Place the scales on a flat, hard surface, not on a carpet or uneven ground. * Warm up your hands and feet if they are cold to improve blood circulation before measuring. * If the electrodes are cold, place the scales in a warm room before use. * If your hands or feet are too dry, wipe them with a damp cloth before stepping on the scale.
J
jhillAug 4, 2025
Why GEONAUTE SCALE 300 cannot analyze body fat?
- D
  Donna ChapmanAug 4, 2025
  If your GEONAUTE Scales cannot analyze body fat, total body water, muscle mass, and bone mass, it might be due to these reasons: * Ensure you are barefoot and have full contact with the electrodes. * Assign a User ID, following the instructions in section 3.2 Set Up Your Profile. * Select your User ID if the system provides you with options.
J
jhansenAug 8, 2025
How to fix no display on GEONAUTE Scales?
- S
  Scott MoodyAug 8, 2025
  If there is no display on the LCD screen when you turn on your GEONAUTE Scales: * Make sure the batteries are correctly installed, referring to section 3.1 Insert the Batteries. * Replace all batteries if they are worn.
P
porterseanAug 12, 2025
What to do if GEONAUTE SCALE 300 Scales show low battery?
- J
  Joshua ClarkAug 13, 2025
  If your GEONAUTE Scales indicate a low battery and the device will power off soon, replace all four batteries at the same time.
M
Michelle SummersAug 17, 2025
Why GEONAUTE Scales power off automatically?
- C
  Courtney BerryAug 17, 2025
  If your GEONAUTE Scales are powering off automatically, it is likely due to a low battery. Replace all the batteries.
S
shawna62Aug 21, 2025
What to do if GEONAUTE SCALE 300 show body fat percentage out of range?
- L
  Lance JonesAug 21, 2025
  If your GEONAUTE Scales display that the body fat percentage is out of the measurement range, stop using the scale for measurement.
B
ballenAug 25, 2025
What to do if GEONAUTE SCALE 300 Scales show overload?
- C
  Christopher NelsonAug 26, 2025
  If your GEONAUTE Scales indicate an overload, stop using the scale for measurement.