WARNING: Always test gas line for leaks at connector with soap
water around all connections.
CONNECTING YOUR GAS
CYLINDER
After purchasing your gas cylinder, you will need to set it up with your gas
BBQ. When changing the gas cylinder, it must not be near any source of
ignition.
Position the gas cylinder at the left side of your gas BBQ, keeping in mind that
the bottle must be kept away from heat and in a safe position.
1. When ready to use your gas BBQ, place the regulator onto the gas bottle
valve and push down firmly until you hear it click in to place.
2. Attach the hose to the regulator gas outlet. You will need to push firmly
as it is a tight fit.
3. Once the hose is connected to the regulator it must be secured in place
using one of the two jubilee clips (Part F) supplied.
4. Attach the other end of the gas hose to the gas inlet on the BBQ
appliance. You will need to push firmly as it is a tight fit.
5. Once the hose is connected, use the second jubilee clip to secure in
place.
6. Ensure that the hose is not subjected to twisting which will affect the gas
flow when installing your gas BBQ. The hose must not have undue
tension and must not touch any part of the gas BBQ, which may be hot.
7. Once the gas cylinder is connected to the appliance, you can then start
the flow of gas by turning the small lever on the regulator from its closed
position (horizontal) to its open position (vertical).
11
GFSBBQ1
To Next Page
Loading...
Need help?
General
