George Home Activity cube

To Next Page

A Philip’s / Cross-head

screwdriver for ﬁttings

supplied.

You will need... Assembly...

1. Unpack the

components and

check against the

list below.

2. Place the

components on

a clean surface

to prevent them

from being

damaged.

3. After you have

assembled your

toy, dispose of all

packaging.

Getting started...

A x1

C x4

B x1

D x1

You will have...

Step 1

Lift the top (A) out

of the cube (B).

Step 2

Turn the top over and

slot onto the top of the

cube as shown in the

diagram.

Activity cube

Assembly Guide

IMPORTANT: RETAIN FOR FUTURE REFERENCE

WARNINGS:

• IMPORTANT SAFETY INSTRUCTIONS

• PLEASE READ ALL INSTRUCTIONS CAREFULLY

BEFORE USE AND RETAIN FOR FUTURE

REFERENCE.

• Adult assembly required.

• The hardware contains small screws with sharp points.

Keep unassembled parts out of the reach of small

children.

• WARNING! Not suitable for children under the age of 12

months. Components of this product may break off into

small parts presenting a choking hazard.

• To avoid the danger of suffocation, keep any bags

or packaging away from babies and children. Any

packaging or bags are not part of the toy and must be

disposed of immediately before assembling the toy.

Need help?

Do you have a question about the George Home Activity cube and is the answer not in the manual?

Summary

Activity Cube Assembly Steps

Step 1: Prepare Top and Base

Lift the top (A) out of the cube (B) for initial assembly stages.

Step 2: Position Top on Cube

Turn the top over and slot it onto the cube as illustrated in the diagram.

Getting Started and Components

Unpack and Check Parts

Unpack all components and verify against the provided list.

Prepare Assembly Area

Place components on a clean surface to prevent them from being damaged.

Included Components Overview

Visual identification of parts A, B, C, and D included in the activity cube set.

Critical Safety Warnings

General Safety Instructions

Read all instructions carefully before use and retain for future reference.

Hardware and Child Safety

Keep unassembled parts and hardware away from small children due to sharp points.

Age Restriction and Choking Hazard

Not suitable for children under 12 months; small parts may break off.

Suffocation Risk from Packaging

Keep bags and packaging away from babies and children to avoid suffocation.

Completing Assembly and Usage

Step 3: Secure Top with Screws

Attach the top to the cube using the four screws (C) and a cross head screwdriver.

Step 4: Final Assembly Check

Ensure the activity cube is fully assembled and screws are tightened before use.

Inserting Shapes into Cube

Slot the shapes through the holes in the side of the activity cube.

Inserting Balls into Cube

Slot the balls through the holes in the top of the activity cube.

Toy Care and Maintenance

Assembly Permanence

The toy is only meant to be assembled once; do not dismantle it.

Regular Screw Tightening

Regularly check that all screws are fully tightened for safety and function.

Proper Usage Surface

Use the toy on a flat level surface only.

Customer Support Information

Contact for Assistance

Information for obtaining further details, spare parts, or advice regarding the product.