Georgia Pacific Cormatic User Manual

ENGLISH
Congratulations on choosing to improve the
hygiene and image of your washroom! With
one simple hand motion, the Georgia-Pacific
Cormatic
®
Automated Touchless Towel
Dispenser elevates the image of your facility,
helps improve hygiene, increases operational
efficiency, and helps you support the EPA’s
guidelines to reduce waste.
TOOLS AND SUPPLIES
• Screwdriver
• Power Drill
• Pencil or Pen
• Level (recommended)
• 4 ea. #8 Screws and Wall Anchors
STEP ONE
Unpacking the Dispenser
Open case and locate listed components:
• Cormatic
®
Automated Towel Dispenser
• Dispenser Key
• 4 “D” Cell Alkaline Batteries
• Decorative Strips
• Instruction Guide
• Lifetime Satisfaction Card
If anything is missing from the above list, call
1-866-HELLO GP (435-5647).
STEP TWO
Assembling the Dispenser
1. Locate key on bottom of dispenser. Open dispenser.
2. Load four “D” cell alkaline batteries into battery
compartment. A red light appears when batteries are
properly installed.
3. Close dispenser.The red light will shut off.
OPERATING AND INSTALLATION
INSTRUCTIONS
Automated Touchless Towel Dispenser

Georgia Pacific Cormatic Specifications

General

Brand	Georgia Pacific
Model	Cormatic
Category	Dispenser
Language	English

Summary

Unpacking the Cormatic Dispenser

Identify Dispenser Components

Locate and confirm all essential components for the Cormatic Automated Touchless Towel Dispenser.

Assemble Dispenser Components

Connect the main dispenser unit to its mounting hardware or prepare for direct wall mounting.

Secure Dispenser Installation

Lock the dispenser onto the bracket, listening for confirmation of a secure fit.

Dispenser Installation Procedures

Determine Installation Location

Select a mounting location with adequate clearance and compliance with ADA guidelines.

Mounting Without Brackets

Install dispenser directly to the wall using screws and anchors.

Mounting With Brackets

Attach dispenser using separately sold mounting brackets.

Adjusting Cormatic Dispenser Settings

Adjustable Sheet Length (ASL)

Configure towel length settings for optimal usage.

Adjustable Time Delay (ATD)

Set the delay interval between towel dispensing.

Adjustable Sensor Range (ASR)

Customize the sensor's detection range for dependable dispensing.

Dispense Mode (DM)

Select how the towel is presented to the user.

Operating and Maintaining the Dispenser

Dispensing Towels

Activate the sensor to dispense a towel and tear it for use.

Replacing Dispenser Batteries

Install four 'D' cell alkaline batteries when the low battery light indicates.

Loading Replacement Towel Rolls

Properly install new towel rolls to ensure continuous operation.

Troubleshooting Dispenser Issues

Check for Paper Jams

Inspect the paper chute for blockages and clear if necessary.

Verify Power and Battery Alignment

Confirm battery installation and alignment if the dispenser has no power.

Reactivate Dispenser After Suspend

Re-load the towel roll to reactivate the dispenser from suspend mode.