GERA Starterset Z LED 60 - User Manual

Operating instructions Starterset Z LED 60 Set Status 19.01.2021
(TNR: 33700066 / 33700067) GERA Leuchten GmbH
Instructions for commissioning and operating
the adjustable LED lights
When delivered, the radio remote control and the supplied control unit are already connected to
each other. The teaching of further control units is described under point 3.
1. Radio remote control
2. Preparation of the radio remote control
(1) Unpack the radio remote control
(2) Open the cover on the back of the radio remote control and remove the insulation strip from
the battery compartment. Then close the lid again.
(3) Attach the magnetic holder to the desired location using the double-sided adhesive tape
supplied. Alternatively, the two screws can also be used.
brighter
cold white
Zone buttons
1-6
On / Off button
warm white
Zone buttons 1-6
converter
Control unit
Max. 60 Watts
Max. 36 Watts
Teach button
Power cord
9-way distributor
Insulation strips
Radio remote control
cover
Lock remote control:
Press the brightness and
zone buttons simultaneously
for 5 seconds.
After that, only the on / off
function is active.
Lock remote control:
cw and zone buttons press
simultaneously for 5 seconds.

GERA Starterset Z LED 60 Specifications