Gerber Technology MP+ Series - No Power Up

22
NO POWER UP
Description:
·
Verify plotter is plugged.
· Verify the voltage in the power supply is 29.5V (between V+ and V-).
· Verify the Voltages in the masterboard:
-Voltage 29.5V between TP1 and TP2.
-Voltage 5V between TP1 and TP3.
-Voltage 3.3V between TP1 and TP4.
-Voltage 1.8V between TP1 and TP5.
· Check Power Line Sensor LED is green.
· If necessary, adjust potentiometer to 29.5V (between V+ and V-).
· Check input voltage is between ranges 84 - 264V (between N and L).
I2C
connectors
Battery
I2C
connectors
RFID
module
ALTERA
600dpi
Motor X (carriage)
driver
Motor Y (paper) driver
Motor Z (GCB) driver
Paper encoder
TAG
(CON29)
Paper end
connector
4PH
Power supply
V+ = 30V
V- = GND
EARTH
N
L
Power
30V
GND
EARTH
CARDS ANTENA
(CON28)
I2C
connectors
ALTERA
600dpi
Motor X (carriage)
driver
Motor Y (paper) driver
Motor Z (GCB) driver
Power
TAG
(CON 29)
TP1
RFID
module
I2C
connectors
Paper end
connector
Potentiometer
4PH
Battery
Paper encoder
+V -V NL
NL
TP4
3.3V
TP5
1.8V
TP3
5V
TP2
30V
TP1
GND