Gerber Versa D461723 - User Manual

To Next Page

Ensamblaje de ducha de

Ensemble de douche à main de

Versa™ Slide Bar Assembly

con barra

sur barre coulissante

Flathead Screwdriver /Tournevis á lame plate/Destornillador chato

Phillips Screwdriver /Tournevis Phillips/Destornillador cruciforme

Marking Pencil /Marqueur/Lápiz marcador

Level/Niveau/Nivel

Drill/Perceuse/Taladro

¼” Drill Bit/Barrena de ¼”/Foret de ¼ po (0,6 cm)

• Hardware Provided

/Petit matériel de fixation fourni/Se incluye los herrajes:

Mounting Screw /Vis de fixation/ Tornillo de montaje

Plastic Anchor /Vis d'ancrage en plastique/Sujetador de plástico

Hex wrench /Clé hexagonale/Llave hexagonal

• Installation Steps:

This product is packaged partially assembled. You will need to take some

components apart to install.

INSTALL TOP SLIDE BAR POST

1.Remove cap. Using hex wrench (supplied), loosen set screw and

remove post from slide bar base (Fig 1).

2.Locate where you want to install the slide bar. Use the top post as a

template and mark locations on shower wall using pencil (Fig 2).

3.Using the drill bit, carefully drill four holes.

TIP: INSTALL ONE POST, THEN ASSEMBLE SLIDE BAR AND CONFIRM

HOLE POSITION OF SECOND POST BEFORE DRILLING (Fig 3).

4.Insert the plastic wall anchors into the four holes. You may need to tap

them lightly into position with a hammer (Fig 4).

5.Secure post with mounting screws provided (Fig 5).

6.Place and hold the slide bar with slide body onto the post; it should

"click" into place.Tighten the set screw with supplied hex wrench, then

press the cap (Fig 6).

NOTE: When installed correctly, the slide body will have screw holes

located on the bottom side. See Fig 6.

.)7 giF( rab edils fo mottob rof 6-5 pets taepeR

8. Attach one hose conical to water supply outlet (not included) and the

other conical to handshower (Fig 8).

Fig 2

Fig 1

Post/

montante/

fixation

Slide bar/

Barra/

Barre coulissante

Base/Base/Base

Cap/

Tapón/Capuchon

Slide body/

Pieza deslizante/

Support coulissant

Shown/Mostrado/Illustré

D461724

D461723

mano de

Need help?

Do you have a question about the Gerber Versa D461723 and is the answer not in the manual?

Summary

Tools You Will Need

Hardware Provided

Installation Steps

Install Top Slide Bar Post

Remove cap, loosen set screw, and remove post from slide bar base.

Locate Installation Area

Use the top post as a template and mark locations on shower wall.

Drill Mounting Holes

Using the drill bit, carefully drill four holes for mounting posts.

Insert Wall Anchors

Insert the plastic wall anchors into the drilled holes.

Secure Top Post

Secure the post to the wall using the provided mounting screws.

Attach Slide Bar to Top Post

Place the slide bar with slide body onto the post and tighten the set screw.

Install Bottom Post

Repeat steps 5 and 6 for the bottom of the slide bar.

Connect Hoses

Attach one hose conical to water supply and the other to the handshower.

Removing and Cleaning Flow Controller

Remove Handshower from Hose

Unscrew the conical hose section counter-clockwise to detach the handshower.

Locate Flow Controller

Find the flow controller/check valve in the handshower handle opening.

Clean Flow Controller

Remove debris from the flow controller/check valve.