German pool GIC-BD28B - Troubleshooting Common Issues; Problem Diagnosis Table

P.9
常見故障及處理 Troubleshooting
使用中如發現電磁爐操作上有問題，在送回本公司維修前請先依照下表進行檢查﹕
When you run into any problem operating this product, use the table below to troubleshoot the problem.
If the problem persists, contact our Repairs & Customer Service Centre.
故障現象 Phenomenon 檢查要點 Check-up Items 處理方法 Solution
接通電源，按機底電源開關，
再按“開/關”鍵，電磁爐無
反應。
Power is connected and Main
on/off switch is turned on,but the
induction cooker does not respond
when the on/off button is pressed.
•是否停電?
•府上的自動開關或
保險絲是否發生短路?
•插頭是否脫落或接觸不良?
•Is there a power
shortage in your area?
•Is there a short circuit in the
power source of your home?
•Is the power plug too loose
or not connected well?
•電源恢復後再使用。
•檢查短路原因，排險後才使用。
•插牢或更換插孔後使用。
•Try again after power supply resumes.
•Find out the cause of short circuit
and eliminate it before switching on
the cooker again.
•Re-connect the plug or replace the
power jack.
蜂鳴器斷續鳴響且鍋具不加
熱。
Buzzer beeps continuously and pan
is not heated.
•鍋具不適應?
•鍋具位置不合適?
•Is the pan not suitable for
induction cooking?
•Is the pan positioned properly?
•使用電磁爐適用之鍋具。
•將鍋具放置在電磁爐面板中心。
•Use an appropriate pan.
•Position the pan in the centre of
cook-top.
在正常運作時停止加熱。
Induction cooker stops heating
during normal operations.
•是否空鍋或溫度過高?
•吸氣口或排氣口是否堵塞?
•室溫太高?
•Is the pan empty or cooking
temperature too high?
•Are the air inlet and outlet
being blocked?
•Is the surrounding temperature
too high?
•防止乾燒，降溫後自動繼續。
•待機件冷卻後才使用，並注意
保持內部通風。
•室溫降低後才使用。
•Avoid operating cooker with an
empty pan. Let cooker cool down
before switching it on again.
•Remove obstruction from the vent.
Let induction cooker cool down and
try again.
•Try again after the room cools down.
保溫失控。
Temperature uctuates.
•鍋底是否凹凸不平?
•Is pan bottom not at?
•更換平底鍋具後使用。
•Replace pan with a at-bottomed one.
*以上為常見故障的判斷與檢查，只供用戶作參考之用。
*如遇故障切勿自行修理，避免發生危險及對機件造成損害，請立即找專業技術人員或聯絡本公司作出適當維修。
* Above table enlists the most common problems regarding the operations of the product and their possible causes as well as suggested solutions.
It is strictly for users’ reference only.
* Should there be any product malfunction or breakdown, DO NOT repair it yourself. Contact our Repairs & Customer Service Centre or consult a
licensed technician immediately.