Getinge Meditrax User Manual

Getinge Australia Pty Ltd
PO Box 50, Bulimba QLD 4171, Australia
Phone: 1800 GETINGE
info.au@getinge.com
www.getinge.com/au
MLAI081015.V1
Base plate
retaining latches
Base plate
Feed through here
2. Pull out approximately 15cm of labels and feed the labels down through the label applicator.
Feed label down
Front of label
applicator
Base plate
3. Slide the new label roll into the label roll holder (C) until the label core snaps into place. The labels
should be placed in the holder with the label side facing up.
Labels sit in label roll
holder here
4. Turn the label applicator over and pull the
labels through so they hang over the front
of the applicator. Click the base plate (J)
closed.
5. Feed the labels through and out the back of the
transport unit (L) until the labels emerge
between the tear-off edge (M) and the handle
lever (A).
Transport unit
Tear-off edge
Handle lever
6. Turn the label applicator over and squeeze the handles (A+B) repeatedly to tighten, self align and
cause a printed label to be dispensed.
1. Open the base plate (J) using the base plate retaining latches (G). Slide the latches on both sides of
the label applicator to open the base plate.
To Load the Label Applicator
Meditrax
Label Applicator

Getinge Meditrax Specifications

General

Brand	Getinge
Model	Meditrax
Category	Label Maker
Language	English