GF1965-1 / GF1965-1KD: PeDal Floor exerciser
asseMBlY & oPeraTioN iNsTrUcTioNs
Please saVe THese iNsTrUcTioNs For FUTUre Use
GF1965-1KD-INS-LAB-RevD13
WARNING:Important!Readandunderstandtheseinstructionsbeforeassemblingor
usingtheGF1965-1/GF1965-1KDPedalFloorExerciser.Ifyoudonotunderstandany
partoftheseinstructions,contactahealthcareprofessionalfordirectionintheuse
ofthisproduct.IfthePedalFloorExerciserisnotproperlyassembledandadjusted,
personalinjuryand/ordamagetothePedalFloorExercisercouldresult.
WARNING:
Thisproducthasamaximumweightcapacityof250lb,EVENLYDISTRIBUTED.
WARNING:
Ifcomponentsaredamagedormissing,contactyourdealerimmediately.DO
NOTusesubstituteparts.UseonlyLumexreplacementparts.Non-Lumexreplacement
partscouldcausepersonalinjuryand/ordamagetothePedalFloorExerciser.
WARNING:GFHealthProducts,Inc.assumesnoresponsibilityforanydamageor
injurycausedbyimproperassemblyoruseofthisproduct.
Info: GF1965-1 comes fully assembled, as
shown at right.
AssemblyinstructionsforGF1965-1KD
only
(refertopictureatright)
1. Slide one end of pedal assembly into the leg
brace as shown at right.
2. Slide the other end of pedal assembly into the
other leg brace, aligning all bolt holes.
3. Insert hex bolts through pedal assembly and
leg braces.
Info: Ensure hex bolt heads are trapped in
leg brace hex holes.
4. Install washers and wing nuts on ends of hex
bolts.
5. Install tension knob on top of pedal assembly
as shown at right. Tighten.
GF1965-1
Pedal Floor Exerciser
stirrup
pedal
tensionknob
GF1965-1KD
Pedal Floor Exerciser
pedalassembly
legbrace
hexbolt
legbracehexhole
wingnut
washer
tensionknob