GF Signet 2540 User Manual

10x I.D. 5x I.D.
Inlet
Outlet
Flange
15x I.D. 5x I.D.
Reducer
20x I.D. 5x I.D.
90° Elbow
50x I.D. 5x I.D.
40x I.D. 5x I.D.
25x I.D. 5x I.D.
2 x90° Elbow
2 x 90° Elbow
3 dimensions
Valve/Pump
Vertical mounting is recommended for best
overall performance. Mount at a maximum of
30° when air bubbles are present.
DO NOT mount on the bottom of the pipe
when sediments are present.
Recommended sensor upstream/downstream mounting requirements.
+30°
0°
Process Pipe
- 30°
Signet 2540 High Performance Flow Sensor
English
Warranty Statement .............................................................................. 2
Product Registration ............................................................................. 2
Safety Information................................................................................. 2
Dimensions ........................................................................................... 2
Specifi cations........................................................................................ 3
Sensor Wiring ....................................................................................... 3
Electronics Module Installation and removal ........................................ 4
Installation............................................................................................. 5
Calculating the H Dimension ................................................................ 6
Standard and Hot-Tap Sensor Installation ............................................ 7
Standard Sensor Removal.................................................................... 8
Hot-Tap Sensor Removal...................................................................... 9
Maintenance ......................................................................................... 9
K-Factors ............................................................................................ 10
Ordering Information ........................................................................... 12
Operating Instructions
Location of Fitting
Table of Contents
• English
• Deutsch
• Français
• Español
• Português
• Italiano
• 中文
*3-2540.090*
3-2540.090 Rev. 10 01/19
Pipe fi ttings MUST be installed by a certifi ed
welder only. GF Signet will not assume liability
of any kind for improper fi tting installations.
Sensor Mounting Position

GF Signet 2540 Specifications

General

Brand	GF
Model	Signet 2540
Category	Accessories
Language	English