What to do if the motor will not run on my GFA ELEKTROMATEN Control Panel?
If the motor does not run, verify the motor supply, the motor safety circuit (including manual operator, over travel limits, and motor thermal), whether the FCP03 stop circuit (terminal 3 – 5) is closed, and the FCP03 fuse F4.
Why is the Mains LED off and Fault LED on, and the sounder bleeping on my GFA ELEKTROMATEN Control Panel?
This indicates the mains supply is off. Restore the mains supply to resolve this issue.
What to do if the alarm solenoid will not operate and the shutter doesn't close in alarm on my GFA ELEKTROMATEN FCP03?
Check that the FCP03 is set to Door Type = Solenoid Drop and check Fuse F7.
What to do if the FCP03 lamp doesn't flash when pressing the buttons to enter Set-up or Engineering mode on my GFA ELEKTROMATEN Control Panel?
This can happen if the batteries are not connected. Connect the batteries to resolve this.
What to do if the FCP03 and shutter do not operate by alarm on my GFA ELEKTROMATEN Control Panel?
Check Fuse F8.
Why are the LEDs and alphanumeric display off on my GFA ELEKTROMATEN FCP03 Control Panel?
This can occur if the mains supply and batteries are disconnected, or if the ribbon cable from the front cover to the main PCB is disconnected. Reconnect the mains supply and batteries, and check the ribbon cable.
Overview of the physical arrangement of drives and controls for the fire door system.
Wiring diagram for the main power supply connection to the fire control panel.
Wiring for DLA150W supply and panel open, stop, close commands.
Wiring for DLA250W/500W supply and panel open, stop, close commands.
Wiring for DLA600/800/1000 supply and panel open, stop, close commands.
Connection diagram for the DLA150W alarm release mechanism.
Connection diagram for DLA250W-1000 alarm release mechanisms.
Wiring diagram for connecting a JESAPZ1-2T key switch.
Wiring diagram for connecting a GE3A 3-button control station.
Wiring configuration for single alarm full close activation.
Wiring for single smoke or heat detector full close activation.
Wiring for two smoke or heat detectors full close activation.
Wiring for dual zone alarm full close activation.
Wiring for stage alarm, part close, and full close activation.
Wiring diagram for connecting a reflective photo beam.
Wiring diagram for connecting a thru-beam photo beam.
Procedure for accessing and navigating the panel's setup menus.
Diagram illustrating the configuration settings for Fast-Set 1.
Diagram illustrating the configuration settings for Fast-Set 2.
Diagram illustrating the configuration settings for Fast-Set 3.
Diagram illustrating the configuration settings for Fast-Set 4.
Diagram illustrating the configuration settings for Fast-Set 5.
Detailed explanation of the panel's advanced engineering functions.
General| Brand | GFA ELEKTROMATEN |
|---|---|
| Model | FCP03 |
| Category | Control Panel |
| Language | English |
To Next Page