GGP ITALY SPA MJ 66 User Manual (English)

Other manuals for GGP ITALY SPA MJ 66

Questions and Answers:

S
Sheila WoodwardAug 14, 2025
Why GGP ITALY SPA Lawn Mower has uneven mowing and poor grass collection?
- F
  fraziertoddAug 14, 2025
  Uneven mowing and poor grass collection in your GGP ITALY SPA Lawn Mower can occur due to several reasons: - The cutting-means assembly might not be parallel to the ground. - The cutting means could be inefficient. - The forward speed may be too high compared to the height of the grass. - The collector channel might be blocked. - The cutting-means assembly could be full of grass. To resolve this: - Check the tire pressure. - Realign the cutting-means assembly. - Reduce the forward speed and/or raise the cutting-means assembly. - Wait for the grass to dry. - Remove the grass catcher and empty the collector channel. - Clean the cutting-means assembly.
E
emmacrawfordAug 17, 2025
How to fix GGP ITALY SPA Lawn Mower when the starter motor doesn't run?
- K
  Keith CampbellAug 17, 2025
  If the starter motor of your GGP ITALY SPA Lawn Mower doesn't run when the key is on «START», the electronic circuit board might be blocked due to: - A flat battery. - A blown fuse. - Bad earthing to the engine or the frame. - Disconnected earth connections of the microswitches. - A badly earthed starter motor. - Starting conditions have not been met. To address this, turn the ignition key to the «STOP» position and: - Recharge the battery. - Replace the fuse (10 A). - Check the connections of black earth leads. - Check the earth connections. - Ensure that the starting conditions are met.
J
Julie BrooksAug 21, 2025
How to troubleshoot difficult starting or erratic engine in GGP ITALY SPA MJ 66 Lawn Mower?
- R
  riveramichaelAug 21, 2025
  Difficult starting or an erratic engine in your GGP ITALY SPA Lawn Mower is often due to a fault in carburetion. To solve this: - Clean or replace the air filter. - Flush out the float chamber. - Empty the fuel tank and refill it with fresh fuel. - Check and replace the fuel filter if necessary.
T
timothyreidAug 25, 2025
What to do if GGP ITALY SPA MJ 66 Lawn Mower starter motor runs but the engine doesn't start?
- S
  Sean FryAug 25, 2025
  If the starter motor runs but the engine doesn't start in your GGP ITALY SPA Lawn Mower, it could be due to: - A faulty fuel supply. - Faulty ignition. To resolve this: - Check the level in the tank. - Check the fuel filter. - Ensure the spark plug cap is securely fitted. - Verify that the electrodes are clean and have the correct gap.
N
Nichole DayAug 27, 2025
Why does my GGP ITALY SPA Lawn Mower engine stop?
- L
  Laura MillerAug 27, 2025
  The engine of your GGP ITALY SPA Lawn Mower might stop because the electronic circuit board is blocked due to: - Disconnected earth connections of the microswitches. - A flat battery. - A badly connected battery (poor contact). - A badly earthed engine. To fix this, turn the ignition key to the «STOP» position and: - Check the connections. - Recharge the battery. - Check the engine earth connection.
M
Melissa CarneyAug 31, 2025
Why is my GGP ITALY SPA Lawn Mower vibrating unusually?
- J
  Jonathan GarciaAug 31, 2025
  Unusual vibrations while your GGP ITALY SPA Lawn Mower is working can be caused by: - Unbalanced cutting means. - Loose cutting means. - Loose bolts and screws. To address this: - Check and tighten all the engine and frame bolts.
D
Danielle NashSep 3, 2025
Why is the engine performance weak during cutting with my GGP ITALY SPA MJ 66 Lawn Mower?
- E
  edwin59Sep 3, 2025
  Weak engine performance during cutting with your GGP ITALY SPA Lawn Mower is often because the forward speed is too high in relation to the cutting height. Reduce the forward speed and/or raise the cutting height to resolve this.
B
Brandon RuizSep 7, 2025
Why does my GGP ITALY SPA MJ 66 Lawn Mower engine switch off when engaging the cutting device?
- A
  andrea69Sep 7, 2025
  If your GGP ITALY SPA Lawn Mower engine switches off when the cutting device is engaged, it may be because: - The movement of the lever used to engage the cutting means is too brusque. - You are not ready to engage the cutting means. Try engaging the cutting means more slowly and ensure that the safety requirements are met.
K
karensmithSep 10, 2025
What to do if GGP ITALY SPA MJ 66 Lawn Mower doesn't move when pressing the drive pedal?
- K
  Kimberly LopezSep 12, 2025
  If your GGP ITALY SPA Lawn Mower doesn't move when the drive pedal is pressed (hydrostatic transmission), it is because the release lever is in position «B». Put it into position «A».