GGP ITALY SPA MJ 66 User Manual (English)

Other manuals for GGP ITALY SPA MJ 66

Questions and Answers:

S
Sheila WoodwardAug 14, 2025
Why GGP ITALY SPA Lawn Mower has uneven mowing and poor grass collection?
- F
  fraziertoddAug 14, 2025
  Uneven mowing and poor grass collection in your GGP ITALY SPA Lawn Mower can occur due to several reasons: - The cutting-means assembly might not be parallel to the ground. - The cutting means could be inefficient. - The forward speed may be too high compared to the height of the grass. - The collector channel might be blocked. - The cutting-means assembly could be full of grass. To resolve this: - Check the tire pressure. - Realign the cutting-means assembly. - Reduce the forward speed and/or raise the cutting-means assembly. - Wait for the grass to dry. - Remove the grass catcher and empty the collector channel. - Clean the cutting-means assembly.
E
emmacrawfordAug 17, 2025
How to fix GGP ITALY SPA Lawn Mower when the starter motor doesn't run?
- K
  Keith CampbellAug 17, 2025
  If the starter motor of your GGP ITALY SPA Lawn Mower doesn't run when the key is on «START», the electronic circuit board might be blocked due to: - A flat battery. - A blown fuse. - Bad earthing to the engine or the frame. - Disconnected earth connections of the microswitches. - A badly earthed starter motor. - Starting conditions have not been met. To address this, turn the ignition key to the «STOP» position and: - Recharge the battery. - Replace the fuse (10 A). - Check the connections of black earth leads. - Check the earth connections. - Ensure that the starting conditions are met.
J
Julie BrooksAug 21, 2025
How to troubleshoot difficult starting or erratic engine in GGP ITALY SPA MJ 66 Lawn Mower?
- R
  riveramichaelAug 21, 2025
  Difficult starting or an erratic engine in your GGP ITALY SPA Lawn Mower is often due to a fault in carburetion. To solve this: - Clean or replace the air filter. - Flush out the float chamber. - Empty the fuel tank and refill it with fresh fuel. - Check and replace the fuel filter if necessary.
T
timothyreidAug 25, 2025
What to do if GGP ITALY SPA MJ 66 Lawn Mower starter motor runs but the engine doesn't start?
- S
  Sean FryAug 25, 2025
  If the starter motor runs but the engine doesn't start in your GGP ITALY SPA Lawn Mower, it could be due to: - A faulty fuel supply. - Faulty ignition. To resolve this: - Check the level in the tank. - Check the fuel filter. - Ensure the spark plug cap is securely fitted. - Verify that the electrodes are clean and have the correct gap.
N
Nichole DayAug 27, 2025
Why does my GGP ITALY SPA Lawn Mower engine stop?
- L
  Laura MillerAug 27, 2025
  The engine of your GGP ITALY SPA Lawn Mower might stop because the electronic circuit board is blocked due to: - Disconnected earth connections of the microswitches. - A flat battery. - A badly connected battery (poor contact). - A badly earthed engine. To fix this, turn the ignition key to the «STOP» position and: - Check the connections. - Recharge the battery. - Check the engine earth connection.
M
Melissa CarneyAug 31, 2025
Why is my GGP ITALY SPA Lawn Mower vibrating unusually?
- J
  Jonathan GarciaAug 31, 2025
  Unusual vibrations while your GGP ITALY SPA Lawn Mower is working can be caused by: - Unbalanced cutting means. - Loose cutting means. - Loose bolts and screws. To address this: - Check and tighten all the engine and frame bolts.
D
Danielle NashSep 3, 2025
Why is the engine performance weak during cutting with my GGP ITALY SPA MJ 66 Lawn Mower?
- E
  edwin59Sep 3, 2025
  Weak engine performance during cutting with your GGP ITALY SPA Lawn Mower is often because the forward speed is too high in relation to the cutting height. Reduce the forward speed and/or raise the cutting height to resolve this.
B
Brandon RuizSep 7, 2025
Why does my GGP ITALY SPA MJ 66 Lawn Mower engine switch off when engaging the cutting device?
- A
  andrea69Sep 7, 2025
  If your GGP ITALY SPA Lawn Mower engine switches off when the cutting device is engaged, it may be because: - The movement of the lever used to engage the cutting means is too brusque. - You are not ready to engage the cutting means. Try engaging the cutting means more slowly and ensure that the safety requirements are met.
K
karensmithSep 10, 2025
What to do if GGP ITALY SPA MJ 66 Lawn Mower doesn't move when pressing the drive pedal?
- K
  Kimberly LopezSep 12, 2025
  If your GGP ITALY SPA Lawn Mower doesn't move when the drive pedal is pressed (hydrostatic transmission), it is because the release lever is in position «B». Put it into position «A».

GGP ITALY SPA MJ 66 Specifications

General

Brand	GGP ITALY SPA
Model	MJ 66
Category	Lawn Mower
Language	English

Summary

1. Safety

1.1 How to Read the Manual

Explains how to interpret manual symbols and importance levels.

1.2 Safety Regulations

General safety rules for operation and preparation.

2. Identification of the Machine and Parts

2.1 Identification of the Machine

Details the identification label and its components.

2.2 Identification of Main Components

Identifies and explains the function of the machine's main parts.

3. Unpacking and Assembly

3.1 Unpacking

Instructions for safely removing the machine and components from packaging.

3.2 Fitting the Rear Plate

Step-by-step guide for attaching the rear plate to the machine chassis.

3.3 Fitting the Dashboard and Steering Wheel

Instructions for assembling the dashboard and steering wheel.

3.4 Fitting the Seat

Guide for attaching the operator's seat.

3.5 Assembly of Accessories and Controls

Instructions for assembling blade lever, battery, grass-catcher, mulching, and discharge guard.

4. Commands and Control Instruments

1. Steering Wheel

Explains the function of the steering wheel.

2. Parking Brake Lever

Details the operation of the parking brake lever.

3. Blade Engagement and Brake Lever

Explains the blade engagement and brake lever functions.

4. Cutting Height Adjusting Lever

Describes how to adjust the cutting deck height.

5. Key Ignition Switch

Explains the functions of the key ignition switch.

5. How to Use the Machine

5.1 Safety Recommendations

Crucial safety advice for operating the machine.

5.2 Why the Safety Devices Cut In

Explains how and why safety devices function.

5.3 Directions Before Starting

Essential checks and operations before starting to mow.

Seat Adjustment Before Starting

How to adjust the operator's seat for comfort and safety.

5.3.2 Refuelling

Instructions for safely refuelling the machine.

5.3.3 Tyre Pressure

Importance and method for checking tyre pressure.

5.3.4 Preparing the Machine and Fitting Exit Guards

How to prepare the machine and fit the correct discharge accessory.

5.3.5 Checking Machine Safety and Efficiency

Final checks to ensure safe and efficient operation.

5.4 Using the Machine

General guidance on operating the machine.

5.4.1 Starting

Step-by-step instructions for starting the engine.

5.4.2 Moving Without Mowing

How to move the machine when not cutting grass.

5.4.3 Braking

How to safely brake the machine.

5.5 Grass Cutting

General advice and techniques for cutting grass.

5.5.1 Engaging the Blade and Forward Movement

How to engage the blade and start moving forward.

5.5.2 Cutting Height Adjustment

How to adjust the cutting height using the lever.

5.5.3 Lawn Maintenance

Tips for maintaining a healthy lawn through proper mowing.

5.5.4 Slopes

Safety precautions for operating on slopes.

5.5.5 Emptying the Grass-Catcher

Instructions for safely emptying the grass-catcher.

5.5.6 Emptying the Collector Channel

How to clear blockages in the collector channel.

5.5.7 End of Mowing

Steps to take at the end of a mowing session.

5.5.8 End of Work

Final actions to take at the end of the workday.

5.5.9 Cleaning the Machine

How to clean the machine after use.

5.5.10 Storage and Inactivity for Long Periods

Instructions for storing the machine during long periods of non-use.

5.6 Transporting

Safety guidelines for transporting the machine on vehicles.

6. Maintenance

6.1 Safety Recommendations

Safety precautions to take before performing maintenance.

6.2 Routine Maintenance

Table outlining regular maintenance tasks and frequencies.

6.2.1 Engine

Instructions for engine maintenance, including oil changes.

6.2.2 Rear Axle

Information about the maintenance of the rear axle unit.

6.2.3 Battery

Maintenance advice for the battery to ensure its longevity.

6.3 Interventions on the Machine

Procedures for specific machine interventions and repairs.

6.3.1 Cutting Deck Alignment

How to adjust the cutting deck for an even cut.

6.3.2 Replacing Wheels

Steps for safely replacing the machine's wheels.

6.3.3 Changing and Repairing Tyres

Guidance on tyre repair and replacement.

6.3.4 Replacing a Fuse

How to replace a blown fuse in the electrical system.

6.3.6 Dismantling, Replacing and Remounting the Blade

Instructions for safely removing, replacing, and refitting the cutting blade.

7. Environmental Protection

8. Troubleshooting

8.1 Starting and Engine Problems

Solutions for starting difficulties, engine erratic running, or stopping.

8.2 Cutting and Performance Issues

Troubleshooting uneven cuts, poor collection, vibrations, and blade engagement.

8.3 Drive and Braking Problems

Solutions for uncertain braking, erratic movement, and drive issues.

9. Accessories on Request

1. Rear Discharge Guard Kit

Optional kit for rear grass discharge.

2. Towing Hitch

Accessory for towing a small trailer.

3. Kit for "Mulching"

Kit to chop and leave grass cuttings on the lawn.

4. "CB02" Maintenance Battery-Charger

Charger to maintain battery charge during storage.

5. Loth Cover

Cover to protect the machine from dust when not in use.

10. Specifications

Related product manuals

GGP ITALY SPA ML 484

72 pages

GGP ITALY SPA MC 534 TR

176 pages

GGP ITALY SPA ML 534 TR/TR-E