Need help?Do you have a question about the Ghibli & Wirbel FR 15 E 38 and is the answer not in the manual?
General| Tank capacity (solution) | 15 L |
|---|---|
| Power supply | 230 V / 50 Hz |
| Brush motor power | 250 W |
| Brush speed | 140 rpm |
| Working width | 385 mm |
General overview and safety advice before using the machine.
Identifies the main components of the machine using a diagram.
Instructions for unpacking, checking contents, and reporting damage.
Lists all accessories provided with the machine.
Guides the user through the initial assembly steps.
Details the electrical connection procedure for the E version of the machine.
Step-by-step guide for attaching the brush to the machine.
Instructions and safety warnings for charging the battery in the BC version.
Explains the function of the LEDs and buttons on the control panel.
Specific instructions for charging the battery in the BC Hybrid version.
How to adjust the angle of the machine's handle for optimal cleaning.
Guidance on moving and positioning the machine during operation.
Instructions for filling the clean water tank with water and detergent.
Essential checks to perform before starting the machine.
Steps to prepare the machine and choose the correct operating cycle.
How to adjust brush pressure for different floor types.
Procedure for adjusting the front wheel on BC version machines.
Step-by-step guide on how to operate the machine for cleaning.
Procedures for safely stopping and powering down the machine.
Instructions on how to park the machine correctly after use.
Alerts for error signals and potential issues during machine use.
Explains how to read and interpret the machine's working time timer.
Steps to empty the recovery water tank after use.
Procedure for daily emptying and cleaning the clean water tank.
Procedure for daily cleaning the recovery water tank.
How to properly clean the squeegee unit.
Steps for cleaning the clean water filter on a weekly basis.
Guide for replacing the brush when it is worn or damaged.
Instructions for replacing worn or damaged squeegee rubber blades.
How to adjust the squeegee's angle of incidence for optimal drying.
Procedure for replacing blown fuses in the BC version of the machine.
Solutions for when the machine does not start when the central button is pressed.
Diagnosing and fixing issues where the brush fails to rotate.
Troubleshooting steps for when the aspirator is not functioning.
Solutions for when the machine does not dry properly, leaving water traces.
Reasons and solutions for when no water comes out from the machine.
Addressing issues related to poor cleaning performance.
Electrical schematic for the BC version of the machine.
Electrical schematic for the BC Hybrid version of the machine.
Electrical schematic for the E version of the machine.
To Next Page
