Chapter 5 Parameters
VFD-E Series
Revision August 2006, 01EE, SW--PW V1.03/CTL V2.03 5-67
Group 5: Multi-step speeds and PLC (Process Logic Control) parameters
05.00 a1st Step Speed Frequency Unit: 0.01
05.01 a2nd Step Speed Frequency Unit: 0.01
05.02 a3rd Step Speed Frequency Unit: 0.01
05.03 a4th Step Speed Frequency Unit: 0.01
05.04 a5th Step Speed Frequency Unit: 0.01
05.05 a6th Step Speed Frequency Unit: 0.01
05.06 a7th Step Speed Frequency Unit: 0.01
05.07 a8th Step Speed Frequency Unit: 0.01
05.08 a9th Step Speed Frequency Unit: 0.01
05.09 a10th Step Speed Frequency Unit: 0.01
05.10 a11th Step Speed Frequency Unit: 0.01
05.11 a12th Step Speed Frequency Unit: 0.01
05.12 a13th Step Speed Frequency Unit: 0.01
05.13 a14th Step Speed Frequency Unit: 0.01
05.14 a15th Step Speed Frequency Unit: 0.01
Settings 0.00 to 600.0Hz Factory Setting: 0.00
The Multi-function Input Terminals (refer to Pr.04.05 to 04.08) are used to select one of the
AC motor drive Multi-step speeds. The speeds (frequencies) are determined by Pr.05.00 to
05.14 as shown above.
To Next Page
Loading...