D.1 The Steps for PLC Execution .............................................................D-1
D.2 The Limit of PLC ................................................................................D-3
D.3 Edition Explanation of Ladder Diagram..............................................D-4
D.4 The Edition of PLC Ladder Diagram ..................................................D-7
D.5 The Example for Designing Basic Program .....................................D-10
D.6 PLC Devices ....................................................................................D-14
D.6.1 Summary of DVP-PLC Device Number....................................D-14
D.6.2 Device Reference Table...........................................................D-16
D.6.3 Devices Functions ....................................................................D-16
D.6.4 Value, constant [K] / [H]............................................................D-17
D.6.5 The Function of Auxiliary Relay................................................D-18
D.6.6 The Function of Timer ..............................................................D-18
D.6.7 The Features and Functions of Counter...................................D-19
D.6.8 Register Types .........................................................................D-20
D.6.9 Special Auxiliary Relays ...........................................................D-21
D.6.10 Special Registers ...................................................................D-22
D.6.11 Communication Addresses for Devices (only for PLC2 mode)D-23
D.6.12 Function Code (only for PLC2 mode) .....................................D-24
D.7 Commands.......................................................................................D-24
D.7.1 Basic Commands .....................................................................D-24
D.7.2 Output Commands ...................................................................D-25
D.7.3 Timer and Counters..................................................................D-25
D.7.4 Main Control Commands..........................................................D-25
D.7.5 Rising-edge/falling-edge Detection Commands of Contact ......D-25
To Next Page
Loading...