- 9 -
Open the GHL Control Center and choose the dosing unit. If the dosing unit is not displayed, you must
add the device through the „Administrate“ button in the top menu bar.
Connect GHL Control Center with the dosing unit by pressing the „Connect“ button in the top menu bar.
After the GHL Control Center is connected you can access the settings for each pump via the
navigation menu on the left side. Therefor click on the plus symbol to the left of the „Dose overview“
menu item and choose one of the displayed dosing pumps.
After you‘ve chosen one dosing pump, the new window with all settings for this pump is displayed to
the right of the navigation menu. You can calibrate, refill the pump and set dosing times here.
Click on the „System“ menu item in the navigation menu to change WiFi and network settings.
You can set the connection of the GHL Doser 2 to local network in the new window. The device
connects to local network via WiFi or ethernet cable. Additionally you can choose between dynamic
and static IP address and also the WiFi protection
To Next Page
Loading...
