Need help?Do you have a question about the GHL ION Director and is the answer not in the manual?
General| Dimensions | 200 x 200 x 100 mm |
|---|---|
| Power supply | 12-24V DC |
| Accuracy - pH | ± 0.1 |
| Accuracy - ORP | ± 10 mV |
| Accuracy - Density | ± 0.001 g/cm³ |
| Resolution - pH | 0.01 |
| Resolution - ORP | 1 mV |
| Resolution - Conductivity | 0.01 mS/cm |
| Measurement Parameters | Calcium, Magnesium, Potassium, Sodium, Strontium, Lithium, Boron, Barium, Ammonium, Nitrate, Chloride, Bromide, Iodide, pH, ORP, Temperature, Conductivity, Salinity, Total Dissolved Solids, Resistivity, Density |
| Measurement Range - Salinity | 0 - 50 PSU |
| Accuracy - Temperature | ±0.5°C |
| Resolution - Calcium | 1 mg/L (ppm) |
| Resolution - Magnesium | 1 mg/L (ppm) |
| Resolution - Potassium | 0.1 ppm |
| Resolution - Sodium | 0.1 ppm |
| Resolution - Strontium | 0.01 ppm |
| Resolution - Lithium | 0.01 ppm |
| Resolution - Boron | 0.01 ppm |
| Resolution - Barium | 0.01 ppm |
| Resolution - Ammonium | 0.01 ppm |
| Resolution - Nitrate | 0.1 ppm |
| Resolution - Chloride | 1 mg/L (ppm) |
| Resolution - Bromide | 0.01 ppm |
| Resolution - Iodide | 0.001 mg/L (ppm) |
| Resolution - Temperature | 0.1°C |
| Resolution - Total Dissolved Solids | 1 mg/L (ppm) |
| Weight | 1.5 kg |
This equipment must not be used by children or persons with limited capabilities or those unfamiliar with its functions.
The ION Director® is for domestic use only, operated with GHL accessories to measure aquarium water ion concentrations.
Instructions for connecting the MUI sensor to the eight-pin Mini-DIN socket, with handling precautions.
Covers connecting the 24 VDC power supply via GHL Doser 2.1 and warns against mixing 12V/24V systems.
Explains ION Director® connection to GHL Doser 2.1 via PAB, with Doser controlling the measurement process.
Details connection to ProfiLux/Doser Maxi and Doser 2.1 Slave via PAB, with controller managing the process.
Describes connecting the ION Director® as a PAB device to the controller (ProfiLux, GHL Doser).
Provides instructions for mounting the ION Director®, emphasizing water protection and stability.
Mandates an inline filter in the sample tubing to prevent pump damage from impurities.
Details installing the MUI sensor into the measuring cell, including loosening the nut and aligning the slot.
Instructs plugging the sensor into the 'Sensor' socket, reiterating moisture and handling precautions.
Describes preparing the measurement cell and tubes, requiring a 6-hour stabilization for the first measurement.
To Next Page