BEFORE FIRST USE
IMPORTANT :
Charge the battery fully
before initial use. If using the supplied USB
cable, charge overnight until the red LED
goes out. You can also use the MVl Fast
Charger (sold separately) for this initial
charge which should
take no more than 2
hours. Failure to fully
charge the battery
may permanently
reduce its capacity
and lifespan.
LOADING
Slide latch release to
open door, remove
crucible and load
with material (if
using concentrates,
insert pad first). For
dry herb, grind to a
coarse consistency
and load crucible
loosely, level to the top. Fit crucible lid
securely and return to the unit ensuring
there are no gaps between the lid and
crucible as you close the door.
SWITCHING ON
Your MVl arrives in
Shipping Mode and is
preset for use with dry
herbs. To activate the
unit, press and hold the
Mode Button until a
single green LED shows,
then release and the
current battery level
will be displayed. The
unit will now wait in Sleep Mode.
'/ If the battery is removed and replaced,
I
I,
you will need to switch the device on as
above.
PREPARING FOR USE
Extend the mouthpiece
by between ½and¾ of an
inch. IMPORTANT: rest
your thumb on the top of
the heatsink to ensure it
remains level with the top
of the device once the
mouthpiece is extended.
Triple click the Mode
Button to activate Vape
Mode, a single green
LED will display. After
several minutes of inactivity
the device will return to
Sleep Mode.
To Next Page
Loading...