GhostBed Foundation TWIN XL User Manual

Center Frame
The top can be idenfied
by the flat top that travels
the length of the frame.
Twin and Twin Long
foundaons do not use
center frames.
Please Note:
· The Foundaon is to be assembled on a hard flat surface
· It is recommended that two people are available for assembly
· Wood is a natural product. If there are visual discoloraons, knots
· or even minor cracks this will not adversely affect the foundaon
· use or durability.
Phillips screw driver is required for assembly
Connue with step 2 on the other side of this sheet.
60 - Wood Screws for Slats and Top &
Boom Rails (includes 4 extra screws)
Supplied Hardware
Please visit WWW.GhostBed.com for product
informaon and video instrucons.
>Limited 3 year warranty visit
WWW.GhostBed.com to view
and register warranty
>Compliant with CPSC FR1633
· Be aware of rough or sharp edges, use care during assembly
· Please follow steps in order for best results
Fabric Cover
Screws
Le Side Frame
The top can be idenfied by the 1
inch wide rib.
The outside can be idenfied by
the rounded corner.
The top can be idenfied by the 1
inch wide rib.
The outside can be idenfied by
the rounded corner.
Top Slat Bundle (2 sets)
Each set contains 1 top cross
rail and 6 top slats. The top
cross rail and slats are evenly
spaced and connected with
fabric strips.
Boom Cross Rails
Right Side Frame
1. Idenfy components.
GhostBed • 7143 West Broward Blvd
Plantaon, FL 33317 • 855-855-4499
Knock Down Maress Foundaon (Boxspring)
Assembly Instrucons
(KD-Foundaon®)
Made in USA

GhostBed Foundation TWIN XL Specifications

General

Type	Foundation
Size	Twin XL
Height	9 inches
Weight Capacity	750 lbs
Material	Wood

Summary

Knock Down Mattress Foundation Assembly Instructions

1. Identify Components

Identify all included parts: side frames, center frame, slats, rails, fabric cover, and screws for assembly.

2. Position Side Frames

Place the Left and Right Side Frames with the 1-inch wide rib facing upwards and outwards.

3. Install Center Frame

Position the Center Frame between the side frames. Skip if not applicable for your model.

4. Attach First Slat Bundle

Attach the first slat bundle, including the longer top cross rail, to the side and center frames using wood screws.

5. Attach Second Slat Bundle

Attach the second slat bundle, ensuring the top cross rail is flush and slats are secured with screws.

6. Attach Bottom Cross Rails

Turn the unit over and attach the bottom cross rails to the frame corners with wood screws.

7. Install Fabric Cover

Turn the foundation over and unfold the fabric cover, pulling it snugly around the entire foundation.