Gianni Industries DG-800 User Manual

Copyright © Gianni Industries, Inc. All rights reserved.
P-MU-DG-800 Ver. B Published: 2010.11.22
Page: - 1 -/ 8
DG-800 Stand-Alone Proximity Reader
Instruction Manual
I. Features
1. Memory volume up to 1000+10 proximity cards/tokens and PINs
with the programming time up to 0.5 seconds.
2. Access modes:
a. Only Proximity Card (default setting) b. PIN or Proximity Card
c. PIN + Proximity Card
3. Logical memory prevents duplicated card setting.
4. Lockout Function: The controller will lockout for 60 seconds after
entering 5 times invalid codes or cards. (The keypad doesn’t beep
during the period of time).
5. Controller with keypad sound avoids incorrect key-in.
6. Additional input for anti-tailgating function ensures high security
access control.
7. Built-in tamper switch.
8. Non-volatile memory stores all code settings for a long time, even
in the event of total power failure.
9. Dual relays to control door lock and other security devices.
10. Aluminum alloy case designed with vandal resistant screws for
enhanced safety and durability.
11. Epoxy sealed for waterproof grade IP65.

Gianni Industries DG-800 Specifications

General

Brand	Gianni Industries
Model	DG-800
Category	Keypad
Language	English

Summary

Features of DG-800

DG-800 Specification Details

Indicator Status and Default Settings

Beep and LED Indication

Details beep and LED signals for different modes like standby and programming, indicating device status.

Factory Default Settings

Lists default configurations for access mode, master code, relay time, and other parameters.

DG-800 Wiring Diagram and Notes

DG-800 Operation Instructions

Master Code Configuration

Explains the five-digit master code used for programming functions, not for access.

Entering Programming Mode

Describes the procedure to enter programming mode by entering the master code twice.

Setting the Access Mode

Details how to configure access using Proximity Card only, PIN or Card, or Card + PIN.

Setting the Relay Strike Time

Explains how to set the door unlock duration from 00-99 seconds or toggle mode.

Clearing Memory of Cards and PINs

Outlines the steps to erase all stored card and PIN data from the device.

Resetting Controller to Default Value

Provides instructions to restore the controller's settings to their factory defaults.

Adding Card and PIN to Relay 1

Guides the process of registering new proximity cards and PINs to grant access through Relay 1.

Adding Card and PIN to Relay 2

Details the procedure for adding proximity cards and PINs to control access via Relay 2.

Changing Master Code

Explains how to modify the existing five-digit master code for security.

Adding New Master Card to Relay 1

Describes the procedure to set a new master card for managing system configurations.

Adding New Cards by Master Card

Details how to add new access cards using a registered master card.

Turning Anti-Tamper Alarm ON/OFF

Explains how to activate or deactivate the anti-tamper alarm feature for security.

Turning Doorbell Alarm ON/OFF

Guides on enabling or disabling the doorbell alarm function.

Resetting Master Code to Default

Outlines steps to reset the master code to its original factory default.