Giant EnergyPak Plus - EnergyPak Plus Removal; EnergyPak Plus Operation

EnergyPak Plus
INSTALLATION & USER MANUAL
6 / 8
To remove EnergyPak Plus from the bike, simply follow installation procedure in reversed
order, except:
1. After opening the retaining lever with Torx key (step 5-4), pull the lock lever on the
bottom of the EnergyPak Plus to open the lock mechanism.
2. Push the Energypak Plus off the top pillar of the baseplate.
Switch on the bike with the RideControl on/off button on the handlebar.
The battery indicator of the RideControl display will show charge level of the main battery.
HOW TO REMOVE ENERGYPAK PLUS:
STEP 1
9. ENERGYPAK PLUS REMOVAL
Removing the EnergyPak Plus from the bike:
10. ENERGYPAK PLUS OPERATION
Make sure EnergyPak Plus is properly installed and connected to the bike.
Push the button on top of the Energypak Plus.
The led indicator next to the button will show the charge level of the EnergyPak Plus.The
EnergyPak Plus is now connected to the system.
The battery indicator of the RideControl display/leds will show charge level of both
batteries combined.
When the main battery (A) is almost empty, the system will switch to the EnergyPak Plus
(B).
When the EnergyPak plus (B) is empty, the system will switch back to the main battery (A).
The main battery will deliver power for a short time, until the assistance is finally switched
off and the battery indicator on the RideControl starts blinking.
STEP 2
STEP 3
STEP 4
ON/OFF
A
B
B
A