Seat post memory system /
height adjustment procedure
The seat post is designed with memory
system. Before your rst ride, please set your
proper height following below procedure
picture
1. Pull the seat post out to the maximum
extended position (Until stopper touches
seat clamp)
2. Loosen the stopper with 2mm Allen key. (Turn
counterclockwise)
3. Adjust saddle height to the desired position
and tighten the stopper.
4. Tighten seat post quick release.
Caution:
Don’t remove the Allen key; otherwise the
stopper might fall out.
Before you ride
your bike-1st
time setup
Be sure to tighten the saddle clamp and
quick release properly before riding. The
saddle and seat post cannot be twisted
when the fixing screw is in place. Check
with your dealer if you have any doubt.
WARNINGS !
To Next Page
Loading...
