Water inlet installation
Tap selection
Suitable tap
Not suitable tap
The front end should be longer than 0.4in . The tap exit
end face should be flat and smooth, if not file it to avoid
leakage
Check the connection between inlet
hose connector and the tap
1. Swing the inlet hose
gently to confirm if it is
fastened.
2. After installation,open the
tap and check if it leaks.
3. Do not bend the inlet
hose with overstrain.
4. Before each usage, check
the connection between inlet
hose connector and the tap.
Make sure they are firmly
ftted to prevent dropping
from improper installation
position.
Connect the inlet hose with the washing machine
Water inlet installation
Inlet valve connector
Water absorption cushion
Inlet hose nut
1. Do not take off the water absorption cushion. Please
check if the cushion is dropped or damaged before each
usage. If it is, contact the seller immediately.
2. Put the inlet hose nut on the inlet valve connector.
3. Fasten the inlet hose nut and swing it gently to make
sure if it is suitable.
12 13
To Next Page
Loading...