- 32 -8I845GVM-RZ Series Motherboard
English
Frequency/Voltage Control
CPU Clock Ratio
This option will not be shown or not be available if you are using a CPU with the locked ratio.
15X~21X It depends on CPU Clock Ratio.
This setup option will automatically assign by CPU detection.
For Willamette CPU: 8X~23X default: 14X
For C-Stepping P4: 8X, 10X~24X default: 15X
For Northwood CPU: 12X~24X default: 16X
The option will display "Locked" and read only if the CPU ratio is not changeable.
CPU Host Clock Control
If system hangs up before enter CMOS setup utility, wait for 20 sec for times out reboot. When time
out occur, system will reset and run at CPU default Host clock at next boot.
Disabled Disable CPU Host Clock Control. (Default value)
Enabled Enable CPU Host Clock Control.
CPU Host Frequency (MHz)
This feature will be available when "CPU Host Clock Control" is set to Enabled.
100MHz ~ 355MHz Set CPU Host Clock from 100MHz to 355MHz.
If you use FSB400 Pentium 4 processor, please set "CPU Host Frequency" to 100MHz. If you use
FSB533 Pentium 4 processor, please set "CPU Host Frequency" to 133MHz.
PCI/AGP Divider
This feature will be available when "CPU Host Clock Control" is set to Enabled.
Disabled Disable PCI/AGP Divider control. (Default value)
PLL/16, 20, 24, 32, 40 Set PCI/AGP frequency.
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Frequency/Voltage Control
CPU Clock Ratio [15X]
CPU Host Clock Control [Disabled]
Ú CPU Host Frequency(Mhz) 100
Ú PCI/AGP Divider Disabled
Host/DRAM Clock ratio [Auto]
Memory Frequency(Mhz) 266
PCI/AGP Frequency(Mhz) 33/66
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Save Default F7: Optimized Defaults
Item Help
Menu Level`
Incorrect using these features may cause your system broken. For power End-User use only!
To Next Page
Loading...
