` Advanced Memory Settings
&
(Note)
, System Memory Multiplier, Memory Frequency(Mhz)
The settings above are synchronous to those under the same items on the Advanced Frequency Settings
menu.
& Memory Timing Mode
Manual and Options are: Auto
&
When using a non-XMP memory module or is set to Disabled, the value
is set to
or
` Standard Timing Control, Advanced Timing Control, CAD Bus Setup Timing, CAD Bus
only when Memory Timing Mode is set to Manual. Note: Your system may become unstable or fail to boot
after you make changes on the memory timings. If this occurs, please reset the board to default values by
` Advanced Voltage Settings
This sub-menu allows you to set CPU, chipset and memory voltages.
` PC Health Status
& Reset Case Open Status
Enabled Clears the record of previous chassis intrusion status and the Case Open
& Case Open
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& CPU Vcore/CPU VDDP/DRAM Channel A/B Voltage/+3.3V/+5V/+12V/VCORE SOC
` Miscellaneous Settings
&
Allows you to set the operation mode of the PCI Express slots to Gen 1, Gen 2, or Gen 3. Actual operation
Auto
& 3DMark01 Enhancement
- 24 -
To Next Page
Loading...
