Gigabyte G1.Sniper 5 - Page 28

- 28 -
Hardware Installation
9) GSATA3 6/7/8/9 (SATA 6Gb/s Connectors, Controlled by Marvell
®
88SE9230 Chip)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell
®
88SE9230 chip
supports RAID 0, RAID 1, and RAID 10. RefertoChapter3,"ConguringSATAHardDrive(s),"forinstructions
onconguringaRAIDarray.
7
7
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
1
1
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
GSATA3
• ARAID0orRAID1congurationrequiresatleasttwoharddrives.Ifmorethantwoharddrives
are to be used, the total number of hard drives must be an even number.
• ARAID5congurationrequiresatleastthreeharddrives.(Thetotalnumberofharddrivesdoes
nothavetobeanevennumber.)
• ARAID10congurationrequiresfourharddrives.
8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by Intel
®
Z87 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
®
Z87 Chipset supports
RAID 0, RAID 1, RAID 5, and RAID 10. RefertoChapter3,"ConguringSATAHardDrive(s),"forinstructions
onconguringaRAIDarray.
7 1
7 1
DEBUG
PORT
G.QBOFM
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
1
0
SATA3
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
3
2
5
4
7
6
9
8