Gigabyte G1.Sniper Z5 - Page 11

- 11 -
Hardware Installation
Storage Interface  Chipset:
- 6xSATA6Gb/sconnectors(SATA30~5)
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
USB  Chipset:
- 6xUSB3.0/2.0ports(4portsonthebackpanel,2portsavailablethrough
theinternalUSBheader)
- 7xUSB2.0/1.1ports(3portsonthebackpanel,4portsavailablethrough
theinternalUSBheaders)
Internal
Connectors
 1x24-pinATXmainpowerconnector
 1x8-pinATX12Vpowerconnector
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 3 x system fan headers
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 1 x USB 3.0/2.0 header
 2 x USB 2.0/1.1 headers
 1 x serial port header
 1 x Clear CMOS jumper
 1 x audio gain control switch
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x coaxial S/PDIF Out connector
 1 x optical S/PDIF Out connector
 1 x D-Sub port
 1 x DVI-D port
 1 x HDMI port
 4 x USB 3.0/2.0 ports
 3 x USB 2.0/1.1 ports
 1 x RJ-45 port
 5xaudio jacks (Center/Subwoofer Speaker Out, RearSpeaker Out, LineIn,
LineOut,MicIn)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 System voltage detection
 CPU/System temperature detection
 CPU/System fan speed detection
 CPU/System overheating warning
 CPU/System fan fail warning
 CPU/System fan speed control
* Whetherthefanspeedcontrolfunctionissupportedwilldependonthecooleryouinstall.