Gigabyte GA-78LMT-USB3 - 2-3 MB Intelligent Tweaker(M.I.T.)

- 25 -
2-3 MB Intelligent Tweaker(M.I.T.)
Whether the system will work stably with the overclock/overvoltage settings you made is dependent
onyouroverallsystemcongurations.Incorrectlydoingoverclock/overvoltagemayresultindamage
to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced
users only and we recommend you not to alter the default settings to prevent system instability or
other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If
this occurs, clear the CMOS values and reset the board to default values.)
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
MB Intelligent Tweaker(M.I.T.)
`
IGX Configuration [Press Enter]
CPU Clock Ratio [Auto] 2800Mhz
CPU NorthBridge Freq. [Auto] 2000Mhz
Core Performance Boost
(Note)
[Enabled]
CPB Ratio
(Note)
[Auto] 3100Mhz
Turbo CPB
(Note)
[Disabled]
CPU Host Clock Control [Auto]
x CPU Frequency(MHz) 200
PCIE Clock(MHz) [Auto]
HT Link Width [Auto]
HT Link Frequency [Auto] 2000Mhz
Set Memory Clock [Auto]
x Memory Clock x6.66 1333Mhz
`
DRAM Configuration [Press Enter]
********
System Voltage Optimized
********
System Voltage Control [Auto]
x NorthBridge Volt Control Auto
x DDR3 Voltage Auto
x CPU Voltage Control Auto
x CPU NB VID Control Auto
Normal CPU Vcore 1.3250V
Normal CPU Vcore NB 1.2000V

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
`
(Note) This item is present only when you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
IGX Configuration

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
``
Internal Graphics Mode [UMA]
UMA Frame Buffer Size [Auto]
x Surround View Disabled
Onboard VGA output connect [Auto]
VGA Core Clock control [Auto]
x VGA Core Clock(MHz) 350
& IGXConguration
& Internal Graphics Mode
Allows you to determine whether to allocate system memory for the onboard graphics controller.
Disabled Disables the onboard graphics controller.
UMA Allocates memory for the onboard graphics controller from the system memory. (Default)
& UMA Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics controller.
MS-DOS, for example, will use only this memory for display. Options are: Auto (default), 128MB, 256MB,
512MB, 1024MB.