Gigabyte GA-7PESH3 - Page 24

Hardware Installation
- 24 -
5/6/7/8/9/10) CPU0_FAN/CPU1_FAN/SYS_FAN1/SYS_FAN2/SYS_FAN3/SYS_FAN4
(CPU Fan/System Fan Headers)
The motherboard has two 4-pin CPU fan headers, four 4-pin system fan headers. Most fan headers
possess a foolproof insertion design. When connecting a fan cable, be sure to connect it in the
correct orientation (the black connector wire is the ground wire). The motherboard supports CPU fan
speed control, which requires the use of a CPU fan with fan speed control design. For optimum heat
dissipation, it is recommended that a system fan be installed inside the chassis.
• Be sure to connect fan cables to the fan headers to prevent your CPU and system from
overheating. Overheating may result in damage to the CPU or the system may hang.
• Thesefanheadersarenotcongurationjumperblocks.Donotplaceajumpercapontheheaders.
PinNo. Denition
1 GND
2 +12V
3 Sense
4 Speed Control
DEBUG
PORT
G.QBOFM
1
1
DEBUG
PORT
G.QBOFM
SYS_FAN1
SYS_FAN4
SYS_FAN2
SYS_FAN3
4) PWR_DET1 (PMBus connector)
5
1
PinNo. Denition
1 SMB CLK
2 SMB DATA
3 SMB Alert
4 GND
5 3.3V Sense
CPU1_FAN
CPU0_FAN
1
DEBUG
PORT
G.QBOFM