Gigabyte GA-7PESH3 - Page 25

- 25 -
Hardware Installation
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 P5V
• ARAID0orRAID1congurationrequiresatleasttwoharddrives.Ifmorethantwoharddrives
arecongured,thetotalnumberofharddrivesmustbeanevennumber.
• ARAID10congurationrequiresfourharddrives.
7
1
(Note) WhenaRAIDcongurationisbuiltacrosstheSATA6Gb/schannels,thesystemperformanceof
  theRAIDcongurationmayvarydependsonthedevicesareconnected.
7
1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
13/14/15/16) SATA3/SATA4/SATA5/SATA6 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5 Gb/s
standard. Each SATA connector supports a single SATA device.
11/12) SATA0/SATA1 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and
1.5Gb/s standard. Each SATA connector supports a single SATA device.
When SATA_DOM0/1 jumper
are set to 2-3 pin:
When SATA_DOM0/1 jumper
are set to 1-2 pin: