Gigabyte GA-890FXA-UD5 - Configuring GIGABYTE Sata2;Jmicron JMB362 SATA Controller

- 85 - Appendix
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Figure 1
Step 2:
Save changes and exit BIOS Setup.
5-1-2 Conguring GIGABYTE SATA2/JMicron JMB362 SATA Controller
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. See the table below for the SATA controllers and their corresponding SATA
ports. Then connect the power connector from your power supply to the hard drive.
B. Conguring SATA controller mode in BIOS Setup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to Inte-
grated Peripherals. To enable RAID, see the table below for conguring different SATA Controllers for RAID.
Controller Connectors BIOS Settings
GIGABYTE GSATA2_6/7 Set Onboard GSATA/IDE Ctrl
to
Enabled
SATA2 Set Onboard GSATA/IDE Mode
to
RAID/IDE
JMicron eSATA ports Set Onboard ESATA controller to Enabled
JMB362 Set Onboard ESATA Mode
to
RAID
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
OnChip SATA Controller [Enabled]
OnChip SATA Type [Native IDE]
x OnChip SATA Port4/5 Type IDE
x OnChip SATA RAID5 Support Enabled
OnChip SATA3.0 Support [Enabled]
Onboard GSATA/IDE Ctrl [Enabled]
Onboard GSATA/IDE Mode [RAID/IDE]
Onboard ESATA controller [Enabled]
Onboard ESATA Mode [RAID]
Green LAN [Disabled]
Onboard LAN1 Function [Enabled]
Onboard LAN1 Boot ROM [Disabled]

SMART LAN1 [Press Enter]
Onboard LAN2 Function [Enabled]
Onboard LAN2 Boot ROM [Disabled]

SMART LAN2 [Press Enter]
Onboard Audio Function [Enabled]
Onboard 1394 Function [Enabled]
Onboard USB 3.0 Controller [Enabled]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
